Would have posted yesterday, but I didn’t get home from the auto show until almost 2AM.
The wiring to the distributor on N/A’s is pretty simple.
The engine harness 4 wire plug-----distributor side wiring
Black/white stripe= 12V ignition power------Black/white stripe splices to all components
Yellow/blue stripe= Tach signal------ Larger blue wire going into ignition module inside
Black= CID - signal------Black wire going to external CID sensor
Yellow=CID + signal-----Red wire going to external CID sensor
Single wire plug:
Green/yellow stripe=barometric ignition advance-----Smaller blue wire going to ignition module inside