Tech, Repairs, Upgrades > Capri XR-2 89-94
New header design
Gaz:
--- Quote from: Rocketman on August 12, 2018, 09:07:20 PM ---I have a GT2860RS "disco potato" Garrett ball bearing turbo on the shelf here, saved for a special project. It's a T25 flange.
Have been looking into getting a TIG welder.
If I ever get around to mocking it in an engine bay I'll pass the fitment info to you
--- End quote ---
Any way you could send it to me?
WashiestSnake:
Hey Gaz I have a TD04 would you be able to make a header for that?
Gaz:
Ya sure you betcha!
WashiestSnake:
What would the cost be do you think? I'm looking to get it done after my cars all back together.
Gaz:
--- Quote from: WashiestSnake on August 28, 2018, 09:18:58 AM ---What would the cost be do you think? I'm looking to get it done after my cars all back together.
--- End quote ---
What flange is that again?
Navigation
[0] Message Index
[*] Previous page
Go to full version