TeamCapri
Tech, Repairs, Upgrades => Capri XR-2 89-94 => Topic started by: bryanknight on May 28, 2008, 04:03:00 PM
-
does anyone know how to check the check engine light from the ecm i know you put a wire from one plug to another and look on the dash for the light flashes but which ones??? thanks
-
???? anyone ????
-
not me, im suprised rocket hasnt jumped on this yet.
-
someone has to know because how are you checking the codes for the check engine light ??? i am working on fixing the crank pulls right not now but i would like to know how to check the codes when i get it running again
-
You have to jumper the green connector IIRC...but there are 3 wires going into it. I am not sure which of the lines it is.
If I can dig up my manual I'll try to find out for you.
-
Ground the STI connector RH rear corner of engine compartment. Mine is green. The wire will be yellow.
-
i used to go to advance auto parts and have them plug their scanner into the car... then someone broke it. Now they only have odb2 scanners.
-
this is what i believe they had http://www.amazon.com/gp/product/B000KID2ZC (http://www.amazon.com/gp/product/B000KID2ZC)
it should work, as i believe our cars are fitted with the EEC-IV system, which this thing reads
-
We have MECS (Mazda Engine Control System). The OBD1 scanner might be able tell you basic info but from what I understand its not fully OBD1 compatable.
Spanky, where in PA are you?
-
It says "Post" 1996 for that scanner... ?
-
Rocketman, I'm Corry PA. Northwest corner below Erie, above Pittsburgh.