TeamCapri

Please login or register.

Login with username, password and session length
Advanced search  

News:

New & potential members - due to overwhelming spam registrations, it's been very hard to sort through new registrations. If your account has not been approved, check your spam folder! If not please contact us at admin[AT]teamcapri.com and we'll sort it out for you.

Author Topic: What should be there?  (Read 3191 times)

CapriProject

  • Full Member
  • ***
  • Posts: 171
What should be there?
« on: July 20, 2010, 07:39:00 AM »
In the engine compartment, Driver's side on inner fender. What was held there with a black attached 'cable-tie' & connected to the wire harness?  Here's a piture.  
Logged

Rocketman

  • Administrator
  • Old-Timer
  • *****
  • Posts: 5493
    • 91 BPT AWD Capri & 1991 XR2
    • http://www.werbatfik.com
What should be there?
« Reply #1 on: July 20, 2010, 07:48:00 AM »
If the one on the left is just a single wire, its a connector for any diagnostic equipment that requires a tach signal. It should be close to the connector for the ignition coil.

The other one might be a connector for the cruise control servo?
Logged
1.8L Turbo All Wheel Drive Capri... the "GTXR2"


CapriProject

  • Full Member
  • ***
  • Posts: 171
What should be there?
« Reply #2 on: July 20, 2010, 11:20:00 AM »
A cruise control servo... Both the black 'cable tie' & the 3 or 4 wire connector are secured to the metal fender.  sound right to you?
Yes, the single one would be a 'test' connecton like you said.
Logged

azgtx

  • Old-Timer
  • *****
  • Posts: 548
What should be there?
« Reply #3 on: July 20, 2010, 12:13:00 PM »
Matt is right on!
Clay
Logged