Well heree goes on the brakes I got the calipers from Jegs after I received them , I had some problems trying to install them because of the Pressed bearing situation in the stock rotors, I finally got hold of a 93 mazda 323 steering knuckle, then only to find out that the ends of my half shafts are just way to small, after taking my halfshafts in hand and ny u-joint disassembed in hand I found that the u-joint from the 94 626 would fit on my spline end of the shaft and that would fit into the 323 steering knuckle, (note you also need 94 323 tie rod ends and ball joints) after that I took the steering knuckle with hub to my local parts supply and found that the VW Corado g60 Rotors fit on the hub and bolt pattern perfectly, and this gave me a massive 280mm rotor well vented with hub slots, after that I machined the steering knuckle to accept the calipers, the front hole of the mounting plate had to be moved forward 1.5cm, what they did is cut the end ear of the steering knuckle mounting plate and with argon extended the ear 1.5 cm since most of the stress hits the rear end of the mounting plate there is no problem. All this fit perfectly in my 15" rims with no clearence problems,After everything was assembled the car hadvery low pedal pressure, we found out the master cylinder could not cope with 4 piston calipers,I went back to my 94 323 took of the master cylinder with booster installed it on the capri (fits Perfect) but since the capri master cylinder has the proportioning valve built in, I had to remove the proportioning valve of the 323 which sits on the firewall and then there wass the issue of the plumbing, the 323 master cylinder has 3 outlet ports the capri has 4 finaly after getting some copper tubing I hooked up the system exactly as it was on the 323 ( all the work is done by the firewall you do not have to extend lines to the back of the car) After i completed everything the moment of truth arrived,
WOW IS ALL I CAN SAY the braking is simply unbelievable, the car STOPS better than my A3 Quattro,
This week I just ordered a Haltech E6X from Australia I will keep everyone posted.
any Questions please feel free to ask