I complete the gear with white grease, worm gear and theeth, put everything together.....and nothing
Same as before.... Fxck
This is now my status:
If i turn the knob of the left headlight down (by hand), use the switch at the center console, both headlights pop up.
But if i press the button again, only the right headlight close. The left headlight stays open.
I try to check the motor:
White plug disconnected, to connect with external power:
As i understood to open the headlight:
brown wire is 12V voltage, green wire is ground.
->To close, reverse the wires.
But, if i connect green and brown at the motor plug, the lamp goes up an down, up and down....
Based on another thread, the headlight should goes only up with this connection (brown wire is voltage, green wire is ground)
Is this a normal behavior? that is turns and turns and turns.....
_____________________________________________
Another question:
Is the position of the cooper disk with the cut out's important? I assume, because of the three fingers on the cover:
Headlight modul got 12V power via switch (headlights on)
Send 12V to headlight motor
Motor turns, until a cut out was reached, connection disrupted (by one of the three fingers), Motor stops.
Headlights open
The same to close:
Switch send 12V to the motor
Gear wheel turns until a cut out is reached
Power connection interrupted, headlight in parking position.
I contact the previous owner, he told me that several workshop masters try to solve the problem without success. I open the gearbox, mark the position of the gearwheel with a pen, as reminder when i put everything together. My fear is, during a previous repair try, the gearwheel was misaligned and now the headlight does not reach the end switch.
I hope my description was understandable.....
Thanks!