Do you not have 2 dowel pins in your cylinder head? The way you lay that gasket down, it doesn't look correct. It should be a little tight getting the gasket onto the dowels. If my memory is right (it might not be), there was a dowel that dropped into a hole for a head bolt in the front left and right rear corners of the block/head. Those will hold the gasket in place. If you dig through my long post in the builds thread, at some point I had to run to a mazda dealership and buy the dowels, so there should be a part # in there.
If you do have the 2 dowels on, then yeah something doesn't look right to me.