TeamCapri

Classifieds => Capri Parts => Topic started by: ericjd on December 23, 2009, 08:29:00 AM

Title: I need a Harmonic Balancer
Post by: ericjd on December 23, 2009, 08:29:00 AM

Where can I get a new harmonic balancer,or a known to be GOOD one ?

Title: I need a Harmonic Balancer
Post by: Gostlrs on December 23, 2009, 12:59:00 PM

sold the one i had..2 others are parting out capris right now in the other threads..hit them up

Title: I need a Harmonic Balancer
Post by: rcicustoms on December 23, 2009, 01:01:00 PM

jeez, ya know i have a couple spares.. id give ya one but thats gonna be pricy to ship....

Title: I need a Harmonic Balancer
Post by: ericjd on December 23, 2009, 11:59:00 PM

I'm not looking for a free one. I definitely will pay you for shipping and more if you want. Shipping shouldnt cost that much, I ship laptops all the time which weigh probably at least 3 or 4 times as much and they cost around $25 priority mail, smaller one less. My zip code is 13601. How much do you want ?  Of course I'm gonna shop for the best price but its got to be in like new working condition. The one that is currently on my car that I drive wobbles and I'm hoping that this will cure the rough idle on my car.

Title: I need a Harmonic Balancer
Post by: grasshopper on January 06, 2010, 05:50:00 PM

If your pulley wobbles then you obviously have the short nose crank version and your crank snout is probably munched.
BTW does anybody know how to tell if a motor has a short or long crank snout. My motor is a May 1992 around the time they changed over. I think the pulley was different....different number of holes in the side .
How many holes in the side of your pulley ericjd?

Title: I need a Harmonic Balancer
Post by: grasshopper on January 06, 2010, 05:55:00 PM

I think some of the pulleys off the 89-91 miata/MX5 can be used.
Might be able to use a 93-97 pulley that uses a multi rib belt (not V belt) and the alt+water pump pulley to match. Has anybody done this mod?

Title: I need a Harmonic Balancer
Post by: Gostlrs on January 07, 2010, 12:28:00 AM

mine wobbles and it is not the short nose...

Title: I need a Harmonic Balancer
Post by: bryanknight on January 07, 2010, 11:18:00 AM

hey mine does the same thing an i toke mine to work and put it in a lathe and use mikes to indicate in and i got to within 5 thousands of ture in a lathe and kid you not put it on the car and it looked worse going 3000 rpms faster.. so i repeeded it again same thing i did notice how putting it on and getting anything behind the pullys as they go on changes the outcome but i never did get it round it looks fine it your looking through the wheel well but if you look down through the engine i waited for the crank to break but it didnt so might want to just remove and clean really good and try it again and see if you ask me thats a really shitty design