If you've registered make sure emails from TeamCapri are not landing in your spam folder!
Also look to replace the distributor o-ring.
Quote from: Rocketman on June 10, 2015, 12:23:49 PMAlso look to replace the distributor o-ring.Sorry if this is a little side-tracked, but where would one acquire such a part? I was actually prepping for a valve cover gasket/engine electrical replacement job right now.
New Viton O-Ring. This size fits Mazda/Mitsubishi Cam Angle Sensors and Distributors, and is also used in some domestic cars to seal the thermostat housing. It is a direct replacement for the parts listed below, however unlike the factory parts or most generic parts store replacements that are made of BunaN/Nitrile Rubber, this one is made of Viton. Viton has a much higher temperature tolerance, and thus will normally last much longer than the standard part.VITON 75D Black Size 222High Temperature (400°F) & Chemical/Solvent ResistanceDimensions: 0.125" T x 1.5" ID x 1.75" ODEQUIVALENT PARTSMazda: 9954-10-3801Mitsubishi: MD619648Fel-Pro: 35608 or 427Victor Reinz: 72222Dorman/Motor-Mite/O-Tite: 64222