So I recently purchased a new headlight motor for my drive side because it was no longer working. I put the new one in and it looked a little different than the stock one. I think think much of it because it had the proper bolt pattern and plug in. However I tried to put them up and it seems to be wired backwards, meaning it goes up when it should go down and down when it should go up. I’m not sure how to proceed in this issue, my dad was saying that a pin in the connection was probably switch and needed to be changed but I have no idea how to do that. Has anyone else had this issue?
Also on a note that i’m just curious, does anyone of any after market blow off values to make the distinct turbo noice instead of it being so quiet? (or a way to make the stock one louder?)
Thank you!!