Tech, Repairs, Upgrades > Capri XR-2 89-94

Head Gasket

(1/1)

CapriManxr2:
So I'm in the middle of rebuilding my engine and I realized that on the head gasket, the holes for the coolant galleys are waaaaay smaller on the gasket than the block. I am looking around the internet and I can't find a head gasket with holes the same shape/size as the coolant galleys. are the coolant galley holes small on the head gasket to slow down flow or do I have the wrong head gasket?

CapriManxr2:
Heres a video of the head gasket and the galley holes not matching sizes. https://imgur.com/a/Uxk4FAp

EShepherd:
Do you not have 2 dowel pins in your cylinder head? The way you lay that gasket down, it doesn't look correct. It should be a little tight getting the gasket onto the dowels. If my memory is right (it might not be), there was a dowel that dropped into a hole for a head bolt in the front left and right rear corners of the block/head. Those will hold the gasket in place. If you dig through my long post in the builds thread, at some point I had to run to a mazda dealership and buy the dowels, so there should be a part # in there.

If you do have the 2 dowels on, then yeah something doesn't look right to me.

Navigation

[0] Message Index